Customizable 2D Flip-flops
Add these complementary products to your cart
Customizable 2D Flip-flops using the sublimation technique.
- Flat base material: EVA (Ethylene vinyl acetate).
- Rubber material: PVC.
- Flip-flop color: black
- Surface color: white
- Black straps
- Printing of the Sublimet 2D customizable flip-flops is performed on the top part, with the sides remaining black in colour
- They can get wet without eroding the print
- Ideal for a gift as well as for sporting or toiletry use.
- Sizes available
- 27-28 (17,2 cm)
- 30-31 (19,2 cm)
- 34-35 (22,6 cm)
- 38-39 (24,7 cm)
- 41-42 (27 cm)
- 44-45 (29 cm)
- 47-48 (30,7 cm)
The 2D customizable flip-flops are ready to be used in sublimation. The printable part of the flip-flop is the upper part which is white, while the remainder is in black. The PVC straps that accompany the sandals are black.
- Marking techniques
The sublimation process can vary depending on the press used.
- 1.- Do the printing in mirror mode.
- 2.- It is advisable to let dry the paper for 5 minutes.
- 3.- Preheat the press to 180º.
- 4.- Place the paper correctly above the product and fix it with heat tape. Then, put it on the press.
- 5.- Close the press for 60 seconds and make pressure over the product.
- 6.- Once this time has passed, with the help of protective gloves, take out the product of the press and then remove the paper.
- 7.- Leave cool the product for a few minutes.
If after following our advice you can’t do the printing correctly, please contact with us using the contact form or the telephone: +34 93 486 90 25