Cookie preferences
Your cart
There are no more items in your cart
T-shirt Roly Imola 0427 Man made of Control Dry recycled polyester, to personalize using the sublimation technique. Crew neck and short sleeves. Lower panels in sleeves. Matching overlock seam in armhole and sleeve panel.
Characteristics:
- Material: 50% Recycled Polyester, 50% Polyester (135g/m2)
- Technical fabric, Waffle Interlock
- Control Dry: brings moisture to the surface of the garment, facilitating evaporation
- Type: short sleeves with lower panels in sleeves
- Neck: round with matching covered seams
- ECO removable label
- Colour: various colors
- Available in several sizes
Marking techniques
- Transfer
- DTF
- Sublimation
- Serigraphy
- Textile Vinyl
- Lettering
Product Measurements:
| Sizes | S | M | L | XL |
|---|---|---|---|---|
| Width | 48 cm | 51 cm | 54 cm | 57 cm |
| Height | 69 cm | 71 cm | 72 cm | 73 cm |
Recommendations for garment care:
- Cold wash (max 30ºC)
- Do not bleach
- Do not tumble dry
- Iron at low temperature and inside out (max 110ºC)
- Do not dry clean
A: Altura, Height, Haut
B: Anchura, Width, Largeur
- Finish
- Polyester touch
- Material
- Polyester
- Marking techniques
- DTF
Lettering
Serigraphy
Sublimation
Textile Vinyl
Transfer
168100002-193-L-AMARFL221
New product
Instructions
Temperature and time may vary depending on the press, paper and materials used. Adjust the values based on the result obtained.
- 1.- Do the printing in mirror mode.
- 2.- It is advisable to let dry the paper for 5 minutes.
- 3.- Preheat the press to 200ºC.
- 4.- Place the t-shirt in the press and put the paper above.
- 5.- Close the press for 60-70 seconds and make pressure on the t-shirt.
- 6.- Once this time has passed, with the help of gloves, take the shirt off the press and then remove the paper.
- 7.- Let the fabric cool for a few minutes.
Important!: Do not forget to use protective paper inside textile products so that the ink does not penetrate the other side of the fabric and also prevent the plate from staining and affecting future products.
If after following our advice you can’t do the printing correctly, please contact with us using the contact form or the telephone: +34 93 486 90 25
When I have printed on the shirt, the image has passed through to the other side.
Sublimation can go through the fabric and stain the other side of the shirt. It is advisable to place a separator inside so that this does not happen. For example, cardboard or protective paper would suffice.
The print on the shirt has white dots or lines.
These small marks are produced because a speck of dust has remained on the surface between the fabric and the paper. It is important to thoroughly clean the press and the surface of the shirt before sublimation, for example with a lint roller. The use of protective paper is also recommended.
Customers who bought this product also bought:
- -5%
Tap to zoom
