Shin guard sleeves for sublimation (pack of 2)
Add these complementary products to your cart
Shin guard sleeves for sublimation (pack of 2) with a front pocket to place the shin guards and customizable on both sides. Made of white elastic polyester fabric, with perforations to allow air to pass through and perspiration. They are unisex and available in various sizes. Easy to use since there is no distinction between right and left.
- Material: Elastic polyester.
- Color: White.
- Printing: Both sides.
- Front pocket: to place the shin guards, preventing them from moving from the correct position.
- Material with perforations: allows air to pass through and perspiration.
- Suitable for all types of sports: football, hockey, cycling, skating, combat sports, etc.
- Does not include shin guards.
- Size: available in various sizes.
A flat press is used to carry out the personalization.
|Sizes||Height (cm)||Top width (cm)||Bottom width (cm)|
- Marking techniques
The sublimation temperature and time may vary depending on the press, paper and inks used. Adjust the values based on the result obtained.
- 1.- Do the printing in mirror mode.
- 2.- It is advisable to let dry the paper for 5 minutes.
- 3.- Preheat the press to 185ºC.
- 4.- Place the t-shirt in the press and put the paper above.
- 5.- Close the press for 70 seconds and put pressure on the product.
- 6.- Once this time has passed, take the sleeve out of the press and then remove the paper.
- 7.- Leave it cool for a few minutes.
If after following our advice you can’t do the printing correctly, please contact us using the contact form or the telephone: +34 93 486 90 25